Ash Veneer Edgebanding

4.8 (134) · $ 6.50 · In stock

Ash hardwood veneer edgebanding. 10mil thick with two backing options, Hot-Melt Glue or Paper-Back. Cover any cheap plain wood to make it look like its made of solid ash hardwood.
Ash wood veneer edge banding Sold in three widths 7/8”, 1, and 2. Purchase by the 25 foot section or by the full roll. HM Glue full rolls are 250’. Full roll of paper back edgeband is 500’. For multiple units purchased, the longest possible continuous piece will be sent. If a specific length is required, please contact us. Felt/Paper Backer: This edgeband will adhere to most surfaces. Rough sanding is necessary on smooth surfaces before applying. It is recommended to apply a thin layer of contact cement to both the surface being covered and the edgebanding. The contact cement should be tacky before applying edgebanding to surface, this should only take a few minutes. Gently press edgeband onto the surface and work out any air bubbles with gentle pressure. Full roll with this backer is 500’. Hot Melt Glue Backer: A high quality EVA hot melt adhesive is on the back. There is no additional adhesive needed with this glue. This edgeband will adhere to most surfaces. Rough sanding is necessary on smooth surfaces before applying. Before applying hot iron, cover with cotton cloth. It is recommended to move the hot iron in a circular pattern until adhesive adheres to surface. Scorching will occur if hot iron is left too long in one spot. Full roll with this backer is 250’.