ESSMO™ Galaxy Black Glitter Sparkle Heat Transfer Vinyl HTV DG22 – EzAuto Wrap

4.9 (162) · $ 4.00 · In stock

Material Specification: PU Composition Thickness:230 Microns / 9.8 Mils (Please make sure plotter is capable of cutting such thickness) Heat pressure sensitive backing Glitter Finish Application Instruction (Home Iron) Set iron dial between Cotton and Linen Cover design with Kraft paper or non-stick cover sheet Place o

Material Specification:

PU Composition
Thickness:230 Microns / 9.8 Mils (Please make sure plotter is capable of cutting such thickness)
Heat pressure sensitive backing
Glitter Finish

Application Instruction (Home Iron)

Set iron dial between Cotton and Linen
Cover design with Kraft paper or non-stick cover sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 10-15 seconds
If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.

Application Instructions (Heat Press)

Cut in reverse
Weed excess material
Preheat all fabric prior to pressing for best results
Apply design at 305°F/150°C-160°C for 12-15 seconds
let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.

Applies to:

100% Cotton
Poly / Cotton Blends
100% Polyester
Leather

Laundering:

Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent (Max 60°C)
Dry on normal dryer setting
Do not bleach or dry clean

Note: Material will be rolled for shipment. Due to the nature of the material, wrinkles might appear after unroll. In this case, peel off the transfer tape (clear film) and re-apply transfer tape onto the film with heavy flat item on top such as yellow page for 15 minutes, the film will be back to the flat shape.