Shellac bubbles when drying - Finishing - Carbide 3D Community Site

I’ve had this actually happen with Roasted Red Oak and this Mahogany piece. It seems to always seal the first side nicely then When I go over the other side, the shellac has small bubbles. I think this is caused by dried wood because it also happened with polyurethane brushed on. What is the technique for preventing this? Any way to recover the piece? I’ve done this one like 4-5 times now. Scuff with a red scotch brite pad and thin layer of sealer. I’m thinking a flat razor to flatten it agai

Shellac bubbles when drying - Finishing - Carbide 3D Community Site

Wood surface has lots of white bubbles/spots after applying second

3D Printed Fixtures - Gallery - Carbide 3D Community Site

3D Printed Fixtures - Gallery - Carbide 3D Community Site

3D Printed Fixtures - Gallery - Carbide 3D Community Site

Really bad cut, wrong bit? What happened?! - Shapeoko - Carbide 3D

Wood surface has lots of white bubbles/spots after applying second

3D Printed Fixtures - Gallery - Carbide 3D Community Site

Output not matching file - Carbide 3D Community Site

Shellac bubbles when drying - Finishing - Carbide 3D Community Site

Output not matching file - Carbide 3D Community Site

SO3: XXL Mega-Enclosure and Dust Collection - Shapeoko - Carbide